Receiver Hitch Recommendation for 1954 Ford F-250 Truck

Updated 05/21/2020 | Published 05/19/2020

Products Featured in This Question

Curt Trailer Hitch Receiver - Custom Fit - Class IV - 2"

(254)

$310.04

Curt Trailer Hitch Receiver - Custom Fit - Class IV - 2"

(143)

$328.35

Question:

Hey there I am interested in class III or IV hitch for my 1954 Ford F-250 3/4 ton stake truck, would like a bolt on if possible, Frame outside width is 34” I can send pics and more measurements. Any assistance would be great Thanx

asked by: Mike F

Expert Reply:

Curt and Draw-Tite don't list any specific hitch fits for a vehicle that old, but luckily enough, cab/chassis trucks typically use a 34 inch wide frame and there are tons of those available.

I'd recommend the Curt # C14082. This Class IV hitch has a 12K towing, 1K tongue weight capacity. To absolutely confirm the fit, before ordering you'll want to measure the height difference (also known as the drop) between the underside of the frame member and the underside of the rear bumper (if there is one). This ensures that the bumper won't get in the way of the receiver tube. The Curt # C14082 has a drop of 4-1/2 inches. So if your vertical distance between the bottom of the bumper and the underside of the frame member is less than 4-1/2 inches, the # C14082 would be a great choice. You'll need to drill your own mounting holes in the underside of the frame, as those on the hitch very likely won't perfectly match up.

The Curt # C14355 is for a newer Ford Super Duty truck, which uses a wider frame so that hitch wouldn't work.

expert reply by: Mike L