What Is the Hub Bore of the Kodiak 13" 8K Disc Brake Kit
Updated 05/21/2020 | Published 05/19/2020
Products Featured in This Question
Question:
What is the hub bore? Do they have both 4.88 and 4.75? Can you provide me with the different part Numbers for each?
asked by: Matthew L
0
Expert Reply:
The Kodiak 13" 8K Disc Brake Kit part # K2HR858AE is designed to be used with the Grease Cap for Kodiak 8,000-lb Disc Brake Kits part # KPCAP which has a threaded diameter of 2-7/8". Therefore, that would be the hub bore opening on the hub.
I am not sure if this answered your question but if you can provide more insight on what it is you are trying to do that may better help me understand.
expert reply by:
Conner L
0
Product Page this Question was Asked From
Kodiak Disc Brake Kit - 13" Hub/Rotor - 8 on 6-1/2 - E-Coat - 8,000-lb AL-KO/Quality
- Accessories and Parts
- Trailer Brakes
- Disc Brakes
- LH
- RH
- 8000 lbs
- Brake Assembly
- 8 on 6-1/2
- Hub and Rotor Assembly
- Kodiak
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Replacement Hub and Drum for a Dexter 8-133
- Article: Trailer Wiring Diagrams
- Q&A: How to Measure to Determine the Size Trailer Brakes Needed For Hydraulic Drum Replacement
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Instructions to Wire a Trailer for Electric Brakes
- Q&A: Comparing the eTrailer and Dexter Electric Trailer Brake Kits
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Q&A: Replacement Caliper Solution for Tie Down Engineering 46304
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Q&A: What Gauge Wire Should be Used to Wire Trailer Brakes
- Article: Electric Trailer Brakes: How They Work & What to Buy
- Article: How to Measure for Trailer Hitch Drop