Recommended Air Springs For 1997 Chevy Blazer 4WD 4-Door S-10
Updated 05/06/2020 | Published 05/04/2020
Products Featured in This Question
Question:
Hi there all. Just ditched the horrid rear leaf bottom overload plate that made the rear hop going over ANYthing! Rode like old buckboard! Now can your air sbock setup fit?
asked by: Steve B
Expert Reply:
I do have an option for you but the Air Lift 1000 Universal Air Spring Kit part # AL60902 is not a good option for the Chevy Blazer because they install inside coil springs.
I recommend to use the Air Lift Ride Control Air Helper Springs part # AL59536 which is designed to replace the jounce bumpers to level out the suspension and fix rear sag if you are experiencing that. The air bags provide a much better ride quality compared to the other more dense rubber jounce springs. The AL59536 is specific for the 4-door 4WD Blazer S-10.
I recommend to add the Air Lift Load Controller II Compressor System for Air Helper Springs part # AL25592 to inflate the bags easily from the cab of the truck.
Product Page this Question was Asked From
Air Lift 1000 Universal Air Spring Kit - Rear
- Vehicle Suspension
- Towing/Load Leveling
- Air Springs
- Suspension Only
- Light Duty
- Rear Axle Suspension Enhancement
- Air Lift
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: What Air Bags Work with the B&W Turnoverball Part # BWGNRK1116 on a 2018 Ford F-250
- Q&A: MORryde X-Factor Crossmember For 2022 Keystone Cougar 30BHS & Bearings
- Article: Frequently Asked Questions About Transmission Coolers
- Q&A: Trailer is Still Swaying when Using Curt TruTrack Weight Distribution
- Q&A: Will the Derale 16-Pass Electra-Cool Remote Transmission Cooler Kit Work w/ a 2005 Chevy Silverado?
- Q&A: How To Charge Slide-In Truck Camper Battery While Driving
- Q&A: What Does Brophy Camper Scissor Steps part # SS03 Weigh
- Q&A: Where Does Scissor Step AS23 Install Typically at Rear of Camper