Step Pad Replacement for Step Bars on a Chevy Silverado 2500
Updated 07/26/2012 | Published 07/24/2012
Products Featured in This Question
Question:
I have side bars on my chevy silverado 2500. I do not know the manufacturer. They are not marked but they are 21inch long and are held in place by five snaps. The snaps are plastic and integral with the step pad. So, the step pads are one piece. I need replacements due to the sun. Do you have any suggestions? I would appreciate any advice you might have. I measured the mount holes from front to rear: 3 5/8, 5 5/8, 6 3/8 and 3 5/8. Looks like step pad #23-0001 will work?
asked by: Joe F
Expert Reply:
The Westin Replacement E-series Step Pad, # 23-0001, measures 3-5/8, 5-5/8, 6-3/8, 3-5/8 inches from one end pin to the other. I have attached a photo showing the measurements I took for you. It is 21 inches long and 3 inches wide. This certainly does sound like the correct pad for you based on the measurements you have provided.
This pad is a replacement for a Westin E-series bar. If you had Westin bars, they should say Westin on the pads.
The pads are held onto the bar using barrel clips. You will need 5 of part # 23-0002.
Product Page this Question was Asked From
Replacement Step Pad for Westin E-Series Nerf Bars - 21" Long x 3" Wide - Qty 1
- Accessories and Parts
- Nerf Bars - Running Boards
- Step Pad
- 5 Pegs
- 21 Inch Long
- With Clips
- Westin
more information >
Continue Researching
- Q&A: Replacement Step Pads for Back Country Nerf Bars on 2001 Toyota Tundra
- Q&A: Replacement 21 inch by 3 inch Nerf Bar Pad Recommendation
- Q&A: Replacement Step Pads for Nerf Bars on 2007 Chevrolet Silverado
- Q&A: What to do if Holes Don't Line Up Correctly for Replacement Step Pad for Westin E-Series Nerf Bars
- Q&A: Replacement Step Pad For 3 Inch Nerf Bars With 20 Inch By 3 Inch Pad
- Q&A: Replacement Step Pad for 3" Round Nerf Bar with 4-Hole Pattern
- Q&A: Replacement Step Pads for 3" Round Aries Round Nerf Bars