Can Jensen Antenna # 1181039 Fit 2005 Jeep Liberty and Fit Hole Already Drilled
Updated 04/15/2020 | Published 04/14/2020
Question:
I just purchased a radio antenna and mt for a 2005 jeep liberty. After the fact it is a replacement so I am wondering if the original hole in the side of the jeep will be too big for this mt. as it says to drill a hole one quarter inch. The hole now is about one big as this will be a replacement and it doesnt work,can I send it back. Thank you
asked by: Howard W
Expert Reply:
The Jensen antenna part # 1181039 does fit standard stereo AM/FM antenna ports like what your Liberty would have and should work easily for you. In an unlikely scenario where your hole is too big you could pretty easily source washers to help take up the extra space.
Product Page this Question was Asked From
Jensen RV Antenna - Top or Side Mount - Rubber Mast - 14" Tall
- RV Antennas
- Radio
- Roof
- Side
- Black
- Jensen
more information >
Continue Researching
- Q&A: Replacement Trailer Hub/Drum for Dexter 8-257
- Q&A: RV Storage Cover For a Riverside Retro 135 Travel Trailer With Rear Entry Door
- Q&A: Recommended 5th Wheel Hitch for MORyde Orbital Pin Box on 2019 Forest River Arctic Wolf
- Q&A: What Toilet will Replace My Thetford Part Number 42053? Will the # TH35SE Work at an Angle?
- Q&A: Looking For Replacement Marker Light SAE A PC2 DOT 17 For A 2022 Surveyor Legend
- Q&A: Replacement Motor for Atwood Landing Gear
- Q&A: Comparing LaSalle Bristol (PVC) And Alpha Systems (TPO) Replacement Roof Membranes
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams