Is a Programmer Needed to Use a Cold Air Intake System on a 2009 Ford F-250
Updated 07/12/2012 | Published 07/10/2012
Question:
Will I need a programmer when using this air intake setup? 2009 Ford F250 4X4 Thank
asked by: Todd G
Expert Reply:
A programmer is not necessary to use a cold air intake system. Once an intake system is installed, you will not need to add any other components unless you want to improve your engine performance beyond the capabilities of the intake system. This intake system is designed for 6.4 liter diesel trucks only. I have attached the installation instructions for you to view.
If you wanted to add a monitor to view your engine performance or a programmer to tune your engine for even greater engine performance, then you could look at the Edge Insight CTS2 Display, # EP84130, or the Edge Evolution CS2 Programmer, # EP85300.
The Insight is only a monitor that will allow you to view your engine performance. The Evolution contains different settings to allow you boost your engine performance based on the setting you are using and monitor your engine performance.
Product Page this Question was Asked From
Edge Diesel Evolution CS2 Performance Tuner - Color Screen
- Performance Chip
- Performance Tuners
- Tuner Only
- Color Screen
- No - Not California Approved
- Evolution
- Edge
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Recommendations for 2007 Chevy 2500 Diesel Fuel Mileage When Towing
- Q&A: Recommended Replacement For A KLI 9000 RV Propane Regulator
- Q&A: Will Edge Tuner Model x00002200 Work With 2006 Ram 2500 5.9L Cummins
- Q&A: Will Truck Bed Cargo Camera For 2020 Ford F-250 Super Duty Be Blocked By Toolbox
- Q&A: 3rd Brake Light Backup Camera for 2019 Ford F-350 That Can be Viewed While in Drive
- Q&A: Will BAKBox 2 Work with RetraxPRO MX Tonneau Cover for 2017 Ford F-350 Long Bed
- Q&A: Troubleshooting Pilot Light of Furrion RV Oven that won't Stay Lit