Wiring of Pins of Momentary Switch part # 337SW710 Explained
Updated 03/17/2020 | Published 03/15/2020
Question:
Do you have a picture of what terminals are wired to what?
asked by: Frank F
0
Expert Reply:
On the backside of the Momentary Switch part # 337SW710 there are four terminals that you'd wire to the wind and unwind power/ground wires. A1 is power for wind, A2 is ground for wind, B1 is power for unwind, and B2 is ground for unwind. See attached picture.
expert reply by:
Jameson C
0
click to enlarge
Product Page this Question was Asked From
Momentary On/Off Switch - Heavy Duty - 50 Amp
- Accessories and Parts
- Dump Trailer Parts
- Switches
- Momentary Switch
- Black
- Buyers Products
more information >
Continue Researching
- Q&A: Correct Replacement for 10 Inch x 1-3/4 Inch Braking Assemblies
- Q&A: Replacement Trailer Clearance LED Lights with 2 3/4 Mounting Hole Spacing
- Q&A: Can Kodiak Caliper Fit with Tie Down Engineering Disc Brakes
- Q&A: How Do I Troubleshoot No Power on My Superwinch Terra 35 Winch?
- Q&A: Is There a Powered Drive Kit for the Ram Square 2-Speed Jack
- Q&A: Availability Of Electric Conversion Kit For Square 2-Speed Jack E26FV
- Q&A: Replacement Trailer Jack for Weld On Mount Shelby Jack Model Number 5874A8
- Article: How to Measure a Trailer Axle
- Article: How to Charge a Dump Trailer Battery