What is the Neck Diameter on the Replacement Angling Cylinder for Western Snowplows
Published 02/13/2020
Question:
Hello, I am trying to find a cylinder like this that will fit inside of a steel tube. Could you tell me what the largest outside diameter is on the neck of this unit so that I can be sure it will fit inside our tubes? Thank you!
asked by: Garrett S
0
Expert Reply:
I had the Replacement Angling Cylinder for Western Snowplow # 3371304220 pulled from our warehouse so that I could measure this for you. Using a digital calipers I measured the outside diameter on the neck of the unit at 2.95".
I've also included a diagram of this as well.
expert reply by:
Erik B
0
click to enlarge
Product Page this Question was Asked From
Replacement Angle Cylinder for Western Hydraulic Snow Plow - 16" Stroke - Single Acting
- Snow Plow Parts
- Western Plow Parts
- Hydraulics and Hoses
- 16 Inch Long
- Cylinders
- SAM
more information >
Continue Researching
- Q&A: Recommended Jack for 4 Horse Gooseneck Trailer
- Q&A: Installation Time for Blue Ox BX1128 Flat Tow Base Plate Kit for 2016 Jeep Grand Cherokee
- Q&A: Max Pressure Rating of Replacement Lift Cylinder part # 3371304201
- Q&A: Recommended Replacement Rooftop AC Unit For A Dometic 57915.621 RV AC System
- Q&A: Will The WS55RR Ball Platform Fit The Weigh Safe Hitch w/ Built-In Scale WS68RR?
- Q&A: Will the Gen-Y Anti-Rattle Work with Weigh Safe Ball Mount?
- Q&A: Lift Cylinder vs Angle Cylinder For Western Hydraulic Snow Plow
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: Slipper Spring Trailer Suspension System Review
- Article: Where to Position the Trailer Axle?