Should Fuses on Boat Wiring Show any Resistance When Tested
Updated 02/10/2020 | Published 02/09/2020 >
Question:
What should the ohms reading be on fuses 37,38, and 73
asked by: Odest H
0
Expert Reply:
Ohms is a measurement of resistance. And fuses aren't designed to put any resistance on a circuit when they are functioning properly. So if you ohmed out a fuse you should get basically zero ohms. Resistors on the other hand are designed to put a specific amount of resistance on a circuit for various reasons.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: How to Test Brake Controller without Trailer Connected
- Q&A: Recommended Bike Rack and Dual Hitch Adapter for Carrying E-Bikes While Flat Towing
- Q&A: Recommended Flat Tow Setup for a 2026 Ford Maverick
- Q&A: Looking for Replacement Hydraulic Gear Pump 196895
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Trailer Turn Signals Both Blink when Just Left Turn Signal is Activated
- Article: Brake Controller Installation: Starting from Scratch
- Article: Brake Controller Installation for 2007 (New Body Style) - 2013 GMC Sierra and Chevy Silverado
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV
- Q&A: Troubleshooting Right Side Trailer Lights Not Working, Left Side Working Correctly
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Q&A: How to Activate 12V Trailer Power Circuit on 2017 Ford F-350 Super Duty
- Article: Ugly RV Makeover: How to Change Outdated RV Lighting

