Hitch Plate for 1995 Ford F-350 Cab and Chassis

Question

Question:

Hitch plate for 1995 Ford F-350. Which plate should I buy for a 1995 Ford F-350

asked by: GREGORY J

0

Expert Reply:

The correct hitch plate for your 1995 Ford F-350 cab and chassis (these hitch plates will not work with pick-up trucks) is the Buyers Products Hitch Plate with 2" Receiver Tube - Ford # 3371809060A, Buyers Products Hitch Plate with 2-1/2" Receiver Tube - Ford # 3371809061A, or Buyers Products Hitch Plate for Pintle Mounting - 1/2" x 15-1/2" - Ford # 3371809030B.

I have added links to video reviews for you to check out as well.

expert reply by: Kyle S

0

Answer 1

The Buyers Products Gooseneck Hitch Plate #3373014981 is a universal fit product that requires professional installation. This 13.5 x 42-inch gooseneck hitch can be welded on top of a structural steel bed or bolted to the truck frame and body. The…

view full answer...

Answer 2

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 3

Good day, Deon, thanks for reaching out. We do have a hitch plate for the 2022 Ram 4500 cab and chassis. We have one with a built-in 2" receiver, or with bolt holes for a pintle mount. Take a look at the following: - Buyers Products Hitch Plate…

view full answer...

Answer 4

Hey Eric, do you have any trailer wiring at all currently like a 4-way or is there nothing at all there? Also, you said 7-way round but did you mean 7-way blade instead? Do the pins look like the one on the left or the right? Left is blade and right…

view full answer...

Answer 5

I just went out to the warehouse and measured the Curt Trailer Hitch Receiver item #C15845. I have attached a couple of diagrams with the dimensions of this hitch on them. From the center of the back bolt to the front of the receiver is 26" The…

view full answer...

Answer 6

Hi Frank! To attach the Buyers Products Hitch Plate #3371809061A you will want to use two 5/8" Grade 8 bolts on each side. The length will need to be verified by measuring your frame as I do not have that handy, unfortunately. What will you be…

view full answer...

Answer 7

There isn't anything like an autonomous controller that would step up if the factory controller fails. I'd simply bypass the existing factory brake controller. The GM ITBC, although it works better now than the earlier models has been…

view full answer...

Answer 8

The width of the tab you marked in your picture is 2.9" and the height is 6.32". I have attached the full dimensional drawing of the #3371809065 below for your reference.

view full answer...

Answer 9

A flashing OC message on the Valley Journey HD brake controller means that the trailer brake circuit is lost or intermittent. With no trailer connected, the brake controller might think there is a connection for some reason. It will also do this for…

view full answer...

Answer 10

Pintle hitches are made to fit certain sized Lunette rings. The rings that we carry are only available in 2-1/2" or 3" diameter sizes. For example, the Curt Pintle Hook for 2" Hitches #C48004 fits lunette ring couplers with a minimum…

view full answer...

Hitch Plate for 1995 Ford F-350 Cab and Chassis

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching