Is the Custer Red Conspicuity Reflector DOT Approved?
Published 01/09/2020
Question:
Im planning to use these reflectors instead of tape because Im applying over checker plate. The width of these are 1inch compared to 2inch wide for the tape. Is the 1inch width acceptable to DOT?
asked by: Wernher
0
Expert Reply:
Yes. The Red Conspicuity Reflector # RFL-12R is both DOT and NHTSA compliant. These reflectors are 1" wide and 12" long.
expert reply by:
Erik B
0
Product Page this Question was Asked From
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Light Solution for Glo Brite 122R
- Q&A: Recommended Flat Towing Set Up for a 2016 Kia Soul w/ a Manual Transmission
- Article: Trailer Lighting Requirements
- Article: Holiday 2025 | Best Gifts for RVing
- Q&A: Is 2016 Ford F-350 Brake Controller Compatible with Electric Over Hydraulic Brake Actuator
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Q&A: What Happens If you Mix a Radial and Bias Ply Tire on a Trailer
- Q&A: Possible Light Replacement For Monarch 5129 On 1977 Great Divide Trailer
- Q&A: What is the Difference Between the Curt 17200 and Reese 83660 Friction Sway Controls?
- Q&A: What are the Dimensions of the Red and Amber Self-Adhesive Reflector Kit # RE52ARK
- Article: Cleaning Your RV Black Water Tank in 4 Easy Steps
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)