Vehicle Keeps Blowing Fuses When Headlights Turned on with Trailer Connected
Updated 11/25/2019 | Published 11/24/2019 >
Products Featured in This Question
Question:
I have a 2004 Toyota Highlander I connected the factory 4 pin flat electrical harness to the trailer plug in the wiring harness. My trailer has LED lights all new wiring included. My directionals and stop lights work fine. My issue occurs when I turn on the headlights. The factory 10amp fuse blows out, I replaced this with a 15 and then a 25 amp fuse with the same problem. Any help would be greatly appreciated.
asked by: Martin A
Expert Reply:
You're likely on the right track. If your fuses keep blowing out, this is a sign that there is a short somewhere on the system-most likely on the running light circuit. Since you're saying that the trailer has all new wiring-if this was something you installed I would recommend re-checking your wiring to make sure that there isn't an exposed wire (cut, damaged or otherwise) touching the frame of the trailer. The ground wire on the trailer should be checked to make sure it is secured to a paint and debris free surface. If this is a brand new trailer, go ahead and skip that part and move on to the next step, since the issue is going to be occuring on the vehicle.
The most likely cause of a vehicle short is the 4 way connector; make sure that the 4 way connection is free from corrosion, dirt and debris. If there are any signs of corrosion on the 4 way, you'll want to replace it with either # C56107 (with factory towing package) or # 118413 (without factory towing package). If the 4 way is in good condition, you'll want to check the wiring behind the harness to make sure that there are not any cut or damaged wires that are touching the vehicle frame- replace anything that is damaged as needed. You'll also want to check the ground wires on the vehicle harness to make sure that it is grounded to a rust and paint free surface.
If you've gone through these steps and continue to get blown fuses, please let me know and I can continue to troubleshoot this issue with you. I've also linked one of our help articles on troubleshooting a 4 way wiring connection that you may find helpful.
Product Page this Question was Asked From
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: How to Test Brake Controller without Trailer Connected
- Q&A: Recommended Bike Rack and Dual Hitch Adapter for Carrying E-Bikes While Flat Towing
- Q&A: Recommended Flat Tow Setup for a 2026 Ford Maverick
- Q&A: Looking for Replacement Hydraulic Gear Pump 196895
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Trailer Turn Signals Both Blink when Just Left Turn Signal is Activated
- Article: Brake Controller Installation: Starting from Scratch
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV
- Article: Brake Controller Installation for 2007 (New Body Style) - 2013 GMC Sierra and Chevy Silverado
- Q&A: Troubleshooting Right Side Trailer Lights Not Working, Left Side Working Correctly
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Q&A: How to Activate 12V Trailer Power Circuit on 2017 Ford F-350 Super Duty
- Article: 5 Reasons to Convert Your RV Lights to LEDs Today




