Ballmount Rise/Drop Needed for Towing Rental Car Dolly with 2015 Dodge Charger
Published 11/09/2019 >
Products Featured in This Question
Question:
I am hooking up a tow dolly to my 2015 Dodge Charger. I have already had the hitch installed. I currently have a 2” ball mount with a 3.5 . Will that work! I measured the height of the mount to be 9.5” without the ball and the average coupler dimensions of a Uhaul trailer is 18”. That would give me a rise of 8.5”, does that seem right?
asked by: Cora G
Expert Reply:
The closer you can get the hitch ball height to the level height of the trailer (tow dolly in your case), the better. Towing the trailer nose up or down can cause trailer sway, which you'll want to avoid. For best results, you'll want to get the coupler and ball height within 1-1/2 to 2 inches, and it's better to have the coupler slightly lower than the trailer ball than vice versa.
A ball mount with a 7-inch rise like # C45338 would put you right where you need to be, height wise. If you don't have it already, you'll also need a trailer wiring harness for your Charger, part # 118655. I'll link you to an installation video. You'll also need the properly sized trailer ball, tow dollies usually use a 2 inch ball like part # A-90.
The Convert-a-Ball # TK5007 adjustable ball mount would also work for you, but because it's adjustable, you'll get a lot of rattle and noise every time you accelerate and brake. For a short tow, it wouldn't be bad but if you're traveling several hundred miles, you'll be better off getting a non-adjustable ball mount of the proper height like the one recommended.
Product Page this Question was Asked From
Adjustable Ball Mount for 2" Hitches - 9" Rise to 10-1/4" Drop - 5,000 lbs
- Trailer Hitch Ball Mount
- Adjustable Ball Mount
- No Ball
- Steel Shank
- Drop - 10 Inch
- Rise - 9 Inch
- Fits 2 Inch Hitch
- 5000 lbs GTW
- Convert-A-Ball
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Will Furrion Chill Low Profile RV AC Unit Replace Coleman Mach 8
- Q&A: Can a Trailer Ride With the Tongue at an Upward or Downward Angle
- Q&A: What Is Install Kit of Furrion Chill Low-Profile RV AC with Heat Pump
- Q&A: How to Determine Clearance Using B&W Gooseneck Pin Box With 2009 Ram 3500 Short Bed
- Q&A: Can Different Brand Shanks be Used with Most Weight Distribution Systems
- Q&A: How Wide is the Curt Weight Distribution Shank C17132?
- Q&A: Replacement Piezo Striker for Camco Olympian Heater
- Article: How to Choose the Right Trailer Hitch Class
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: Trailer Tire Sizing
- Article: Trailer Wiring Diagrams
- Article: Trailer Hitch Installation Tips
- Article: Types of Trailer Hitches: How and Why to Use Each



