Landing Gear Legs Keep Blowing Fuse Even After New Motor
Updated 10/21/2019 | Published 10/20/2019
Question:
So I replaced my jack motor and installed a new battery. I’m still blowing my thirty amp fuse . Could the relay cause my problem. I bought the motor from y’all just a month ago.
asked by: Mark C
Expert Reply:
If you still continue to blow a fuse on your lading gear legs even with a new motor then that would lead me to believe you have an issue with the wiring or switch. Therefore, I recommend you trace the wires from the motor to the switch and then from the switch to the battery. If I had to guess I would say you have a short in one of these wires but I don't think the relay would be your issue.
The Lippert Components Ignition Proof 5th Wheel RV Landing Gear Switch w/Harness part # LC145236 comes with a new switch and harness so this would be a viable replacement as well.
Product Page this Question was Asked From
Lippert Ignition Proof 5th Wheel RV Landing Gear Switch w/Harness
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Switches
- Lippert
more information >
Continue Researching
- Q&A: How To Choose The Correct Replacement Landing Gears For A 2021 Cherokee Wolfpack 365pack16
- Q&A: Replacement Motor for Lippert Model 1-065-041012-01 Landing Gear
- Q&A: Can a Lippert Manual Landing Gear Set Be Converter to a Dual Motor Setup
- Q&A: What Replacement Lead Leg Do I Need for My 2011 Keystone Montana Trailer?
- Q&A: What Is The Difference Between The Three Fogatti InstaShower Tankless Water Heaters?
- Q&A: Can Demco Recon Gooseneck-to-5th Wheel Trailer Hitch Adapter Coupler Point to Rear of Truck
- Q&A: Troubleshooting Landing Gear Not Lifting 5th Wheel
- Article: Trailer Wiring Diagrams
- Article: How (and Where) to Connect an RV Propane Grill
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps