Bolt Pattern Size on Galvanized Marine Brake Assembly 18787
Updated 06/17/2009 | Published 06/16/2009
Question:
what is the spread on bolt pattern on backing plate
asked by: Dick K
0
Expert Reply:
The backing plate bolt pattern is 2-7/8 inches on center both ways (square). If we can help further let us know.
expert reply by:
Robert G
0
Product Page this Question was Asked From
Demco Hydraulic Drum Brake Assembly - Single Servo - Galvanized - 10" - Left Hand - 3,500 lbs
- Accessories and Parts
- Trailer Brakes
- Hydraulic Drum Brakes
- LH
- 3500 lbs
- Brake Assembly
- Single Servo
- 10 x 2-1/4 Inch Drum
- Demco
more information >
Continue Researching
- Q&A: Do Curt Single Hook Coiled Safety Cables Meet Legal Requirements for Towing
- Q&A: Difference Between Demco 10 inch Drum Hydraulic Brakes and etrailer.com Brand Brakes
- Q&A: Replacement Wheel Cylinders for Demco Kar Kaddy KK360SS
- Q&A: Are Replacement Gaskets Available For A Dexter/UFP A-60 Surge Brake Actuator Master Cylinder
- Q&A: Replacement Hub & Drum For UFP HD-1377-10 & Hydraulic Brakes For Boat Trailer
- Q&A: Replacement Pin for ESCO Trailer Breakaway Kit
- Q&A: Best Hydraulic Drum Brakes For A Boat Trailer With 3,500 Pound Axle
- Article: Double-Eye Trailer Suspension System Review
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision