Is Drilling Required to Install a Trailer Hitch on a 2012 Hyundai Elantra

Updated 03/20/2012 | Published 03/19/2012

Products Featured in This Question

Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"

(70)

$185.93

T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector

(82)

$40.00

T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector

(10)

$57.30

Curt Cam Buckle Stabilizing Strap for Hitch-Mounted Accessories - 61" x 1" - Qty 1

(666)

$16.01

1-7/8" Hitch Ball - 3/4" Diameter x 1-9/16" Long Shank - Chrome - 2,000 lbs

(2621)

$16.53

2" Hitch Ball - 3/4" Diameter x 1-9/16" Long Shank - Chrome - 3,500 lbs

(2621)

$18.47

Question:

Hi there. Im interested in purchasing this hitch for my 2012 Huyndai Elantra. My question is: will have to drill any holes to the bottom of my vehicle to install this hitch?

asked by: Bruno

Expert Reply:

On the 2012 Hyundai Elantra, some models were built in the United States and some were built in Korea. If you have a model that was built in Korea, you will have to drill holes to install trailer hitch # C11303. The dealership may be able to tell you which factory the vehicle was built in. You can also check the frame at the back of the vehicle to determine if it has the holes needed to install the hitch. I have included a link to the installation instructions for you.

The hitch comes with a ball mount, hitch pin and clip. For a ball you can use # 19256 for a 1-7/8 inch diameter or # 19258 for a 2 inch diameter. For trailer wiring, if you have a sedan, use # 118532. For a touring hatchback model, use # 118473. I have included links to the instructions for you for both wiring kits.

If you are using the hitch for an accessory like a bike rack or cargo carrier, Curt requires using stabilization strap # 18050, for their warranty.