Drill Bit Tap for Weld Nut for Trailer Hitch Installation on 2014 Dodge Charger
Updated 07/25/2019 | Published 07/24/2019
Question:
Need to clear the thread on the frame of car what size tap do I need
asked by: Antonio T
0
Expert Reply:
I believe the part you are talking about is the weld nut on your 2014 Dodge Charger where the M12 bolt for the Draw-Tite Trailer Hitch # 76145 installs. For this you need a12 mm x 1.25 tap and drill bit.
expert reply by:
Jon G
0
click to enlarge
Product Page this Question was Asked From
Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 675 lbs TW
- 4500 lbs GTW
- 2 Inch Hitch
- Visible Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: Trailer Wiring Diagrams
- Q&A: Best Trailer Hitch For 2025 Toyota Grand Highlander Max Hybrid Platinum
- Q&A: J-Case Fuse Position For Curt 7-Way Harness On 2024 Honda Pilot Blocked
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Q&A: Ball Mount Recommendation for 2013 Chrysler 300 with Curt Class III Trailer Hitch
- Q&A: What Should the Voltage Output Be at the 4-Way Plug on Curt T-Connector Wiring Harness # 56016
- Article: My Trailer Hitch Doesn't Fit
- Q&A: Availability of Hydraulic Jacks for Horse Trailer
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Recommended 2 Inch Hitch for a 2018 Dodge Charger
- Article: Determining Trailer Tongue Weight
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: Trailer Hitch Installation Tips