Could Support Arms of Stromberg Carlson Bunk be Cut to Lower Height
Updated 07/23/2019 | Published 07/19/2019
Question:
Can I adjust cut the tubes so that I would be able to the front queen bed?
asked by: Billy T
0
Expert Reply:
If you wanted to cut the tubes of the Stromberg Carlson Bunk part # CC-255 to lower the height beyond its current adjustability range you could but it would require drilling new holes in the front support bracket and cutting off the top of it as well to allow for a shorter height.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Stromberg Carlson Trailer Tray Cargo Carrier for A-Frame Trailers - 300 lbs
- RV Cargo Carrier
- Cargo Carrier
- A-Frame Mount
- 300 lbs
- Fixed
- 32 Inch Wide
- 20 Inch Deep
- Steel
- Stromberg Carlson
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Stromberg Carlson Bike Bunk Trailer-Mounted Bike Rack Carrier for A-Frame Trailers - 2"-100 lbs
- Article: Trailer Wiring Diagrams
- Q&A: Will Soft Start Kit for Coleman-Mach RV Air Conditioners Fit a Coleman-Mach 2000?
- Q&A: Replacement Slam Latch Recommendation for Winnebago Minnie Winnie Travel Trailer
- Q&A: Replacement Propane Gas Detector for Atwood 31013
- Q&A: Looking to see how the Torklift PowerArmor locking Battery Box Mounted to a Trailer Tongue?
- Q&A: Testing a Vehicle Side 7-Way Trailer Connector for Proper Function
- Q&A: How to Carry a Generator on an A-Frame Travel Trailer
- Q&A: Which Support Struts Are Compatible With 28' Keystone Travel Trailer With Rear Bumper?
- Article: How to Measure for Trailer Hitch Drop
- Article: Carrying Bikes While Towing a Pop-Up Camper Trailer
- Article: How to Choose a Bike Rack for a Motor Home or RV
- Article: REDARC Tow-Pro Liberty vs Tow-Pro Elite
- Article: Converting Your RV Water Heater to Tankless
- Article: Determining Trailer Tongue Weight