What Type Of Grease Should Be Used With the Roadmaster Anti-Sway Bar Bushings RM205222-10
Products Featured in This Question
Question:
what type of lube should i use when installing these bushings thanx
asked by: Ernie
0
Expert Reply:
When installing the Roadmaster Split Bushing for Anti-Sway Bar part # RM205222-10, I recommend using the LubriMatic Marine Trailer Wheel Bearing Grease part # L154FR. This is the same type of aqualube grease that comes with the kits from Roadamster.
expert reply by:
Conner L
0
Product Page this Question was Asked From
Roadmaster Split Bushing for Anti-Sway Bar - 1-5/8"
- Accessories and Parts
- Anti-Sway Bars
- Anti-Sway Bar Parts
- 1-5/8 Inch Diameter
- Bushings
- Rear Anti-Sway Bar
- Roadmaster
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Can I Flat Tow a 2023 Ford Bronco Using the Recovery Hooks?
- Q&A: Replacement Kwikee Step Motor For a 1999 Fleetwood Southwind Motorhome
- Q&A: Dimensions on Roadmaster Replacement Bracket U Clamp
- Article: How to Manually Light an RV Oven, Furnace, Water Heater, or Refrigerator
- Article: RV Propane 101: How Does My RV's Propane System Work?
- Q&A: Replacement LP Gas Detector for a CCI 7770.2 / Pre Tell 22 Detector
- Q&A: End Link Length for Roadmaster Front Anti-Sway Bar for Motorhomes 590066-00
- Q&A: What Are the Dimensions of Roadmaster Polyurethane Bushing Kit # RM-4139-127
- Q&A: Storage Instructions for Kat's Heaters Handi-Heat Magnetic Heater
- Article: Performance Chips and Modules
- Article: RV Sway Control, Stabilization, and Suspension Enhancement