How Long is the Valterra Bladex Waste Valve for RV Black Water Part T50 From Each Fitting
Updated 07/02/2019 | Published 07/01/2019
Question:
Can you tell me the measurement front to back ie from the LUG side fitting to the Hub side fitting . And how deep is the HUB ?
asked by: Robert G
0
Expert Reply:
The Valterra Bladex Waste Valve for RV Black Water part # T50 measures 4-1/8" from the end of the lug fitting to the end of the hub fitting. The hub fitting is then 1-1/2" deep.
expert reply by:
Conner L
0
Product Page this Question was Asked From
Valterra Bladex Waste Valve for RV Black Water Tank - 3" Hub to 3" Lug
- RV Waste Valve
- Straight Valve
- Single Waste Valve
- 3 Inch Valve Body
- Manual
- 3 Inch Hub
- Stationary Valve
- Valterra
more information >
Continue Researching
- Q&A: Recommended Swing, Swivel, and Tilt TV Wall Mount for a 25 lbs TV
- Q&A: Recommended Solar Panel Expansion Kit that Works w/ Go Power GP-PV-200M Solar Panels
- Q&A: Looking For Upgraded Equalizer And Wet Bolt Kit For 2006 Arctic For 26x
- Q&A: How do I Determine when My Equa-Flex Cushioned Equalizers Needs to be Changed?
- Q&A: Troubleshooting An Everchill RV Refrigerator Freezer Fan That Runs Every Few Seconds
- Q&A: Replacement Wheel and Tire for a 2017 R-Pod 177
- Q&A: What is Difference Between RV Waste Valves Hubs and Spigots
- Article: Cleaning Your RV Black Water Tank in 4 Easy Steps
- Article: Trailer Wiring Diagrams
- Article: How Level Should a Tow Bar Be When Flat Towing
- Article: How to Measure for Trailer Hitch Drop
- Article: Camping Tips for First-Time RVers
- Article: How to Install an RV Awning From Scratch
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)