Thumb Turn Cam Lock That Comes With Straight Latch
Published 06/28/2019
Products Featured in This Question
Question:
We just got the product and went to go install in and everything went fine. I went to put the existing straight 1-3/4inch cam from the key cam lock we are replacing and the opening on the cam is slightly smaller to attach to the cylinder. Do you sell the straight cam made for this product?
asked by: Tom E
0
Expert Reply:
We do not have a latch that works with the Replacement Thumb Turn Cam at this time part # 295-000014. You would have to get the latch with a cam that is guaranteed to fit like Camco Cam Lock part # CAM44323.
expert reply by:
Heather A
0
Product Page this Question was Asked From
Camco Cam Lock - Straight or Offset - Thumb Operated - 3/4" Thick
- RV Door Locks
- Compartment Door
- Cam Locks
- Offset Cam
- Straight Cam
- 7/8 Inch Long
- Silver
- Camco
more information >
Continue Researching
- Q&A: Parts Needed to Add Air Compressor To Air Lift 5000 Air Bags With Braided Lines
- Q&A: Are Red, Marine and Wheel Bearing Grease Compatible with Each Other
- Q&A: Mounting Location for the Repeater on the TireMinder i10 TPMS
- Q&A: What TorkLift Tie-Downs Fit a 2025 Ford F-250 Super Duty Crew Cab with Running Boards?
- Q&A: Is There a Cover for a Single 30 Lb Propane Tank
- Q&A: Thumb Latch Cylinder Measurements
- Q&A: How Waterproof is TorkLift TLA7700L Battery Box
- Article: Trailer Maintenance Schedule
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Article: How to Drain an RV Water Heater
- Article: How to Winterize & De-Winterize Your RV (Simple Guide)
- Article: Cleaning Your RV Black Water Tank in 4 Easy Steps