What Position Should the Hook and Keeper for Enclosed Trailer Doors Be Mounted In
Updated 06/19/2019 | Published 06/17/2019
Question:
Am I not mistaken that the holes are 2.5/16 vertical and 1 horizontal? The mount goes up and down correct? It’s taller than wider...
asked by: Robin D
0
Expert Reply:
Correct, the mounting holes on the Hook and Keeper for Enclosed Trailer Doors part # 383400 are 2-5/16" apart top to bottom (vertically) and 1" apart left to right (horizontally). The actual plate measures to be 3" tall x 1-3/4" wide. Therefore, it is taller than it is wider.
I have attached a few photos to clarify the above.
expert reply by:
Conner L
0
click to enlarge
click to enlarge
Product Page this Question was Asked From
T-Style Hook and Keeper Door Holder for Trailer Rear or Side Door - 4" Hook - Zinc Plated
- Trailer Door Holders
- Hook and Keeper
- Straight
- 4 Inch Long
- 2-5/16 x 1 Inch Hole Spacing
- Steel
- Polar Hardware
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Recommended Door Holder to Hold a Trailer Door at a 45° Angle
- Q&A: What Size Hole Do I Drill In Bed For B&W Gooseneck Turnover Ball In 2026 GMC Sierra 2500 ?
- Q&A: Availability of Victron DC/DC Battery Charger With Lithium Compatibility and Engine On Detection
- Q&A: Spare Tire Cover Needed for a 205/75-15 Size Tire
- Q&A: Greasing Trailer Axle Spindle Where Zerk Fitting Broke Off
- Q&A: Recommended Replacement Manual Override Rubber Plug for a 2021 K-Z Sportsmen Travel Trailer
- Q&A: What Size Hole Saw do I Need to Make the Hole in the Bed of My Truck to Install B&W Gooseneck Hitch?
- Article: What is Boondocking
- Article: Converting Your RV Water Heater to Tankless
- Article: Ball Mount Basics: Weight Capacity, Class, and Size
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Trailer Maintenance Schedule
- Article: How Much Solar Power Do I Need For My RV?