How Does Brake Controller Install in 2008 F-350
Published 06/05/2019
Products Featured in This Question
Question:
Is there after maket that fits into the dash 2008 350ford
asked by: Bryan
0
Expert Reply:
For your 2008 Ford 350 truck the correct install harness is the part # 3034-P for the Draw Tite brake controller part # 5504 that you mentioned. This plugs right into the port you have under your dash.
Check out the install video link I attached to this page for more info as well.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Draw-Tite Activator IV Trailer Brake Controller - Up to 4 Axles - Time Delayed
- Trailer Brake Controller
- Time Delayed Controller
- Electric
- Plug-In
- Under-Dash Box
- Under-Dash
- Up to 4 Axles
- LED Display
- Single Trailer Only
- Draw-Tite
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Recommended Trailer Hitch and Wiring Harness for a 2025 Kia Sorrento Hybrid
- Q&A: Will Kodiak Trailer Hub for 3,500-lb Axles Fit Dexter 80043A Spindle On Boat Trailer
- Q&A: Help Picking Out Replacement Axle for 2004 Ranger Trail Trailer
- Q&A: Replacement Hub and Drum Assemblies for AL/KO 8460 Hubs and Drums
- Q&A: Replacing Wheels on a Trailer with 5 Spoke Utility Hubs and 8-14.5 Size Tires
- Q&A: Can 2020 Kia Soul-GT Turbo DCT be Flat Towed behind Motorhome
- Q&A: Difference Between Tekonsha 119251 and 119250 ZCI Wiring Harness for Mini Cooper
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Troubleshooting Brake Controller Installations
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Double-Eye Trailer Suspension System Review
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Trailer Wiring Diagrams