Is There a Video that Shows How to Operate Tru-Flate Wall-Mounted Tire Inflator # 16-250
Published 07/05/2019 >
Question:
Have not been able to inflate my bike tires with the Truflate compressor. First of all, my co-op purchased multiple units for each building in the complex. After watching the video, I calibrated the compressor to 80 ips, turned it on, and pressed the nozzle to the opening on my tire. The tire did not inflate, and I felt a stream of air gush out of the nozzle. Is there an additional attachment I was supposed to use, or is there something I'm not doing right? Thank you for any assistance you can provide.
asked by: Nathan
Expert Reply:
Yes, I attached a link to this page that details how to install and use the Tru-Flate Wall-Mounted Tire Inflator # 16-250 you referenced. It shows how to properly connect the air chuck to the valve stem as well as set tire pressure etc.
Product Page this Question was Asked From
Tru-Flate Wall-Mounted Tire Inflator - 110 psi - 120 Volts
- Tire Inflator
- Tire Inflator
- Wall-Mount
- 110 psi
- 120V
- Digital Pressure Gauge
- Manual Shut Off
- Tru-Flate
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Pros and Cons of Running Two Inflation Valves or One in Air Bag Suspension Kit on Vehicle
- Q&A: Recommended Suspension Support While Towing a Trailer w/a 2023 Chevy Colorado ZR2
- Q&A: How To Adjust The Roadmaster Exact Center Steering Stabilizer For A More Comfortable Ride
- Q&A: Do I Need a Sliding 5th Wheel Hitch for a 2024 Chevrolet Silverado 2500 w/ a 6-3/4 Foot Bed?
- Q&A: What is the Capacity of Buyers Products 5/8 Forged D-Ring 337B40MP
- Q&A: Size and Grade of Hardware Included with Buyer's Products 5/8 Inch Forged D-Ring Tie-Down 337B40MP
- Q&A: What Is The Distance Between The Mounting Holes On The Buyers Products 5/8" D-Ring 337B40MP?



Nathan
7/5/2019
Have not been able to inflate my bike tires with the Truflate compressor. First of all, my co-op purchased multiple units for each building in the complex. After watching the video, I calibrated the compressor to 80 ips, turned it on, and pressed the nozzle to the opening on my tire. The tire did not inflate, and I felt a stream of air gush out of the nozzle. Is there an additional attachment I was supposed to use, or is there something I'm not doing right? Thank you for any assistance you can provide.