Hole Dimensions for the Optronics Door Grab Handle
Updated 04/20/2019 | Published 04/19/2019 >
Question:
What are the hole locations center to center.
asked by: Doug S
0
Expert Reply:
I went out to the warehouse and found that the center to center measurements of the holes on the Optronics Door Grab Handle # 01180089B are 8-5/16" and 9-1/2". The adjacent holes are about 11/16" apart on center.
expert reply by:
Jon G
0
Continue Researching
- Q&A: Hopkins 7-Way Trailer Connector to Older Featherlite Wiring Recommendation
- Shop: B&B Assist Handle for Molded Grip for RV Entry Door - Black
- Shop: JR Products RV Door Grab Handle - Black
- Shop: Thinline LED Clearance and Side Marker Light - Submersible - 3 Diodes - Rectangle - Red
- Shop: Optronics ThinLine LED Trailer Clearance and Side Marker Light - Submersible - 4 Diodes - Amber Lens
- Shop: Brophy Swiveling D-Ring Anchors w Backing Plates and Hardware - Bolt-On - 2,000 lbs - Qty 4
- Shop: Bauer Products Locking Cam Latch for Cargo Trailers - Matte Black - 300 Series Key
- Shop: Peterson Clearance and Side Marker Trailer Light Kit - Submersible - Incandescent - Red Lens
- Search Results: thinline led
- Search Results: trailer lights
- Search Results: trailer door holders
- Search Results: rv steps
- Search Results: compartment door rv door locks
- Search Results: pull handle
- Search Results: boat anchor
- Video: Optronics LED Side Marker Light and Mid-Ship Turn Signal Feature Review
- Video: Review of the Replacement Cable and Pin for Bright Way Trailer Breakaway Kits
- Video: The Low-Down on the Replacement Cable and Pin for Bright Way Trailer Breakaway Kits
