Shank and Mounting Hole Dimensions of Key Locking Handle # PLR7011L
Updated 03/28/2019 | Published 03/27/2019
Question:
I have a pace stacker will these handles work what size is the squar shaft and what is the hole spacing for mounting
asked by: Al T
0
Expert Reply:
The square shank of the Key Locking Handle # PLR7011L that you referenced is 5/8 inch by 5/8 inch and the mounting holes are separated by 2 inches on center. The shank is also 8-1/8 inches long. If all of those dimensions match up this would fit and work well.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Locking L-Shaped Handle - 8-3/16" Long - Powder Coated Steel
- Trailer Door Latch
- Reversible
- L-Handle Latch
- Keyed Alike
- Built In Lock
- Bolt-On
- Steel
- Polar Hardware
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Will B&W Companion 3370 Fit 2012 Ford F-250 Short Bed With OEM Prep Package
- Q&A: Replacement Hub for a 3/4 Inch Diameter Straight Spindle
- Q&A: Recommended 5th Wheel Hitch for 2025 Ford F-350 With OEM Puck System
- Q&A: Is There a Downside to Using Offset Gooseneck Ball Compared to Non-Offset
- Q&A: How to Choose Correct Axle Placement for Tandem 7K Axles with Slipper Leaf Springs
- Q&A: Can A Separate Handle Be Attached To The Deadbolt Latch # PLR7011S
- Q&A: What Does Shaft of RV Designer L Handle for T & L Handle Locks Look Like
- Article: How to Measure for Trailer Hitch Drop