Mounting Hole Distance to Bottom of Bracket on CE Smith Side Angle Mounting Brackets # CE10211G
Published 12/07/2018
Question:
How high up are the 1/2inch dia holes? I.E. what is the max diameter of roller can you fit inside?
asked by: Grampa D
0
Expert Reply:
The center of the holes on the CE Smith Side Angle Mounting Brackets # CE10211G that you referenced are 2-1/4 inches above the mounting surface. Since the diameter of the roller gets split on either side of it a 4 inch diameter roller would be about as big as I'd recommend.
expert reply by:
Jameson C
0
click to enlarge
Product Page this Question was Asked From
CE Smith Side Angle Mounting Brackets for Boat Trailer Rollers - Galvanized Steel - 1 Pair
- Boat Trailer Parts
- Rollers
- Roller Bracket
- Galvanized Steel
- Fits 1/2 Inch Shaft
- CE Smith
more information >
Continue Researching
- Q&A: Availability of 6' Long Roller Bunks
- Q&A: Looking for 9" Wide Rollers and Brackets for a Holsclaw Boat Trailer
- Q&A: Installing Pal Nuts On Trailer Rollers
- Article: Trailer Lighting Requirements
- Article: Trailer Wiring Diagrams
- Q&A: Can I Use Roller Bunks and Carpeted Bunk Boards Together on Boat Trailer
- Q&A: Dimensions of the Universal Roller Brackets for Boat Trailers # MBSPB
- Article: Spring Towing Readiness Checklist
- Q&A: Weight Capacity of Malone Axis Load Roller for Malone Truck Bed and Roof Load Extender
- Q&A: How to Install Ground Wire To Trailer Connector on Utility Trailer
- Article: Where to Position the Trailer Axle?
- Article: How to Measure for Trailer Hitch Drop
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Troubleshooting 4 and 5-Way Wiring Installations