Is Replacement Handle for Bladex and Valterra Waste Valves Threaded
Published 10/10/2018
Question:
My vehicle is a 2017 Coachmen Freelander. Its the inital blade valve below black water tank. The handle has lost one side. Is the handle a screw on/off?
asked by: Gerald H
0
Expert Reply:
The replacement water tank valve handle part # T1003-6NVP is threaded so it would fit as a replacement for you as long as shank is threaded as well.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Replacement Handle for Bladex and Valterra Waste Valves - Threaded - Plastic - Black
- Accessories and Parts
- RV Waste Valve
- Waste Valve Parts
- Handles
- Valterra
more information >
Continue Researching
- Q&A: Converting 4-Way Trailer Connector to 7-Way on 2009 Toyota Highlander
- Q&A: What Toilet will Replace My Thetford Part Number 42053? Will the # TH35SE Work at an Angle?
- Q&A: Replacement OneControl Advantage Controller For Lippert Level Up RV Leveling System 425749
- Q&A: Is There a Trailer Hitch that Fits 2026 Toyota RAV4 Hybrid
- Q&A: How Should I Wire My Batteries in Parallel While Using the Victron SmartShunt Battery Monitor?
- Q&A: Replacement Adhesive Tape For Curt Spectrum Trailer Brake Controller Control Knob
- Q&A: Will Spring Bars Rated Above Trailer Tongue Weight Make for a Stiff Ride
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Replace Trailer Leaf Springs in 5 Steps
- Article: Double-Eye Trailer Suspension System Review
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: Trailer Maintenance Schedule
- Article: How Does a Trailer Hitch Coupler Work?
- Article: Hitch Anti-Rattle Devices: The Ultimate Guide