How Does a Weld-On Bulldog Jack Install Onto a Trailer
Published 10/14/2011
Question:
gOT THIS JACK A FEW YEARS AGO AND DONT KNOW HOW TO INSTALL IT TO THE TRAILOR. hELP!
asked by: CHUCK M
0
Expert Reply:
This Bulldog Round, Snap-Ring Swivel Jack # BD151101 is a weld on jack. You will need to remove the mounting bracket from this unit and have it welded to the frame of your trailer near the coupler and then reinstall the rest of the jack on to the bracket and you will be good to go at that point.
I attached a link to the installation instructions for this product for you to check out also.
expert reply by:
Jameson C
0
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: How To Replace Welded-On Trailer Tongue Jack for Boat Trailer
- Q&A: Fix For Curt Echo Wireless Brake Controller Locking Up Trailer Brakes At Low Speeds
- Q&A: Trailer Jacks Manufactured in the USA
- Q&A: What is the Difference Between Bulldog and Pro Series Pipe-Mount Swivel Jacks
- Shop: Mighty Cord RV Circuit Tester for 30-amp Outlets
- Shop: Replacement Weld-On Handle Keeper Clip for Bulldog Trailer Jacks - Qty 1
- Q&A: Proper Mounting Location for Side Marker Lights on a Trailer
- Shop: Square Jack w/ Crank - Side Pin Drop Leg - Spring Return - 10K Lift - 25-3/4" Travel
- Shop: etrailer Square Jack - Side Pin Drop Leg - Spring Return - 10K Lift - 25-3/4" Travel
- Shop: etrailer Square Direct Weld Jack - Drop Leg w/ Spring Return - Sidewind - 25-7/8" Lift - 10K
- Shop: etrailer Square Jack wHandle - Foot Lever - Drop Leg - Spring Return - 12K Lift - 26.5" Travel
- Shop: Square Direct Weld Jack w/ Footplate - Drop Leg - Topwind - 29" Lift - 7,000 lbs
- Q&A: 5200 lb Dexter Hub Bearing Kit Recommendation
- Search Results: bulldog jacks
- Search Results: trailer jacks
- Search Results: 10k trailer jack
- Search Results: ram trailer jacks
- Search Results: bulldog trailer jack
- Search Results: pro series trailer jack
- Search Results: dexter trailer bearings races seals caps