How Does UWS Notched Toolbox part # UWS01032 Install in Bed of Truck
Updated 09/10/2018 | Published 09/09/2018
Question:
how does it install in bed
asked by: Jim S
1
Helpful Expert Reply:
Typically the toolboxes like the UWS Notched part # UWS01032 that you referenced install by running nuts and bolts through the bottom of the box through the floor of the truck bed and then securing them underneath the bed.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
UWS Truck Bed Chest - Wedge Series - Offset Lid - Notched Box - 10.4 cu ft - Gloss Black
- Truck Tool Box
- Chest Tool Box
- 20-1/2 Inch Tall
- Aluminum
- 21 Inch Wide
- 55 Inch Long
- Black
- UWS
more information >
Continue Researching
- Q&A: Will the Mounting Hardware for UWS Truck Bed Chests Work with an Aluminum Truck Bed in a Ford
- Q&A: Recommended Cargo Carrier Tool Box For Golf Clubs
- Q&A: Is There Sliding Bed Tray Solution for Truck with Gooseneck
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Comparing Trailer Tongue Tool Box Options - etrailer, UWS, RC
- Q&A: Landing Gear Jack Replacement Recommendation for 2009 Bighorn 3055RL
- Q&A: Toolbox Compatible With 5TH Wheel Hitch In a 2021 Ford F-350 Long Bed With Factory Prep/Puck System
- Q&A: Recommended Replacement for Venture Landing Gear on 2009 Heartland Bighorn 5th Wheel
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box