Measurement to Drill Hole for Gooseneck Ball of 2011 GMC Sierra 1500
Updated 08/27/2018 | Published 08/26/2018
Products Featured in This Question
Question:
The 4 inch hole that has to be drilled in the bed I need measurement for 6 foot bed. 2011 1500 gmc sierra
asked by: Kenny
0
Expert Reply:
The 4 inch hole needed to install the B and W Turnoverball Gooseneck hitch part # BWGNRK1057 in the bed of your 2011 GMC Sierra 1500 short bed will be 44-1/8 inches from the rear truck bed edge. I attached a picture I took from the install instructions that shows this as well.
expert reply by:
Jameson C
0
click to enlarge
Product Page this Question was Asked From
Air Lift Ride Control Air Helper Springs - Rear Axle
- Vehicle Suspension
- Towing/Load Leveling
- Air Springs
- Suspension Only
- Standard Duty
- Rear Axle Suspension Enhancement
- Air Lift
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Rear Air Bags for 2018 GMC Sierra Denali with MagneRide and 6-1/2 Foot Bed
- Q&A: What Air Bags do You Recommend for My 2018 Chevy Silverado 1500 High Country?
- Q&A: Will RoadActive Suspension Increase Unloaded Height of 2023 Chevy Silverado 1500
- Q&A: Best Suspension Enhancement Kit for 2019 GMC Sierra 1500 Elevate
- Q&A: Recommended Mechanical Suspension Enhancement for 2018 Chevrolet Silverado 1500
- Q&A: Air Bags vs. RoadActive Suspension Enhancement For 2023 GMC Sierra 1500
- Q&A: Recommended Suspension Enhancement For 2019 Chevrolet Silverado 1500 LD 4WD
- Article: Fifth Wheel Trailer Hitch Information and Installation Tips
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Article: Flat Towing Package for 2007-2018 JK Jeep Wrangler and Wrangler Unlimited
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Boat Trailer Guides: Which are the Best?