Trailer Hitch Bumper Clearance on a 1998 Subaru Legacy Outback Wagon
Updated 08/21/2018 | Published 08/20/2018
Question:
How far back so my wagman 2 bike rack will work without hitting the back window
asked by: William
1
Helpful Expert Reply:
We have installed the Curt Trailer Hitch Receiver part # C12270 on a similar 2000 Subaru Legacy Outback Wagon and we found that the distance from the hitch pin hole to the outer edge of the bumper is 5-3/4". That is the measurement that you will use to determine if it will work.
I have attached an install video for you as well.
expert reply by:
Conner L
1
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class II - 1-1/4"
- Trailer Hitch
- For Towing
- Class II
- 350 lbs TW
- 3500 lbs GTW
- 1-1/4 Inch Hitch
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Location of the Trailer Wiring Connector on a 2002 Subaru Legacy Outback Wagon
- Q&A: Troubleshooting Fit of Curt Hitch C12270
- Q&A: Trailer Hitch and Wiring Recommendations/Comparisons for a 2006 Subaru Forester
- Article: My Trailer Hitch Doesn't Fit
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Is There a Replacement Lid Support for a Yakima SpaceBooster 1998-2003
- Q&A: Differences Between Three Derale Series 8000 Plate-Fin Transmission Coolers
- Q&A: Is There 2" Trailer Hitch Receiver For 2003 Subaru Outback
- Q&A: Correct Hitch Fitment for a 1999 Subaru Legacy Outback Wagon
- Article: How to Change a Trailer Tire
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Article: How to Measure for Trailer Hitch Drop