Troubleshooting TruXport Tonneau Cover Not Aligning with Truck Bed
Updated 08/13/2018 | Published 08/12/2018
Question:
I had to remove my tonneau cover to repair my two safety straps. Somehow the cover has moved right of center about 4 inches on the cab header bar. I see it slides on groove between the caver and the cab header, but doesnt seem to move. any advice? Id hate to break it. Thanks.
asked by: Michael D
Expert Reply:
As you mentioned in your question, the cover should be able to slide along the groves above the cab header so that you can align it with the bed. If it is not moving like you described then you will want to make sure that the end plugs on the header are removed. The plugs will prevent the unit from moving so this is likely your issue.
If you are still having trouble adjusting the cover please let me know and I will be happy to look into this further.
Product Page this Question was Asked From
TruXedo TruXport Soft, Roll-Up Tonneau Cover
- Tonneau Cover
- Roll-Up - Soft
- Not Rack Compatible
- Opens at Tailgate
- Tailgate Lock
- Standard Profile - Top of Bed Rails
- Vinyl
- Vinyl Grain
- Truxedo
more information >
Featured Help Information
Instructions
Continue Researching
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Q&A: Where to Locate Part Number for TruXedo Tonneau Cover
- Q&A: Replacement Tarp and Velcro Recommendation for 2001 Dodge Ram 1500 6 ft Bed with Truxedo Lo Pro QT
- Q&A: Possible Replacement Snap-On Cover for an Extang Tonneau Cover on a 2004 Dodge Ram 1500 Short Bed
- Q&A: How to Find Replacement Tarp For Extang Platinum Snap-On Tonneau Cover
- Q&A: Replacement RV Stereo Recommendation for Magnadyne Linear Series LS3500CDB
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Trailer Wiring Diagrams
- Q&A: What Size Hole is Needed to Install Sealed Uni-Lite Mini LED Side Marker/Clearance Light # MCL12AKB
- Article: Double-Eye Trailer Suspension System Review
- Q&A: Methods to Remove Trapped Water Inside AL-KO Axle Beam