Is There Drilling Required to Install a Hidden Hitch Trailer Hitch on a 2008 Toyota Yaris
Updated 10/04/2011 | Published 10/02/2011
Products Featured in This Question
Question:
do you have to do any drilling to install the hitch?
asked by: Warren
0
Expert Reply:
I checked the installation instructions for the Draw-Tite Trailer Hitch Receiver # 24819 and you will not need to do any drilling to install this onto your 2008 Toyota Yaris.
I attached the installation instructions for you to check out also.
You may be interested in purchasing the following products to complete your towing setup if you plan on doing some towing:
Tow Ready Custom Fit Vehicle Wiring # 118517 (installation instructions attached)
Hitch Ball # 19256
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Draw-Tite Sportframe Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Trailer Hitch
- For Towing
- Class I
- 200 lbs TW
- 2000 lbs GTW
- 1-1/4 Inch Hitch
- Concealed Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Continue Researching
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Installation Differences Between Curt, Draw-Tite and Hidden Hitch Models for 2010 Toyota Yaris
- Q&A: Recommended Replacement Hitch Hardware Kit for Curt C11480 on 2018 Toyota Yaris
- Q&A: Can The Yakima BackSwing Swing Away Adapter Be Used With A Thule Bike Rack?
- Q&A: Trailer Hitch Mount Bike Rack that Allows Rear Door to Open on a 2004 Toyota RAV4
- Q&A: Will Curt Hitch and Drawbar fit a 2007 Toyota Saris?
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: Trailer Wiring Diagrams
- Q&A: Best Trailer Hitch for Towing with a 2010 Toyota Yaris