Travel Trailer Frame Assembly and Glass
Updated 07/16/2018 | Published 07/13/2018
Question:
I want to purchase a new travel trailer door window from your company. The window I have now does not have any screws inside or outside. How do I remove the existing window to put in the new one I want to purchase? Thank you!
asked by: Tom R
Expert Reply:
If it isn't held in with screws there should be some type of adhesive on it; I wish there was an easy way for me to tell you exactly how but realistically there isn't going to be a way that is particularly easy for you to remove your assembly if it is stuck on with adhesive. The Lippert Components 12" x 21" Inner and Outer Entry Door Window Frame with Seal # LC363369 just snaps together so it is possible you may be able to unsnap your assembly as well.
Product Page this Question was Asked From
Lippert Replacement Window Frame with Seal for RV Entry Doors - Exterior - White
- RV Door Parts
- Entry Door
- Window Frames
- White
- Lippert
more information >
Continue Researching
- Q&A: Where to Mount the 6-Way Bracket on the etrailer Invisible Base Plate Kit e44FV
- Q&A: Can a 50 Amp Watchdog Surge Protector Be Used on a 30 Amp Hookup?
- Article: Trailer Wiring Diagrams
- Q&A: How To Find Correct RV Awning Arm for Trailer Awning
- Q&A: How to Find the Spindle Number on a Trailer Axle
- Q&A: Replacement Entry Door Window Frame
- Q&A: Will Pollak 7-Way Socket Fit with Blue Ox 7-Wire to 6-Wire, Coiled Electrical Cord
- Q&A: Which Pin of Blue Ox 6-Way to 7-Way is for 12 Volt Charge Circuit
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Lighting Requirements
- Article: Converting Your RV Water Heater to Tankless