Details on Fascia Trimming Required to Install a CURT Front Mount Trailer Hitch, 2008 GMC Envoy
Published 09/21/2011
Question:
I am considerting purchasing and installing a Curt Front Hitch on my GMC Envoy, I think it is part number 31055. In the QandA section it says some triming of front facia is required. Do you know how much, do you have a picture of an install, or can you give me the measurements to determine where the trim or hole needs to be - or a Envoy video. Thanks
asked by: Terry S
Expert Reply:
The CURT Front Mount Trailer Hitch, # 31055, is the correct front hitch for a 2008 GMC Envoy. We have not yet had the opportunity to install this hitch on a vehicle so I do not have a video or pictures I could link you to. But I have included a link to the installation details that show the trimming that needs to be done.
There is a diagram that shows where and how much of the underbody trim panel that needs to be trimmed. It is about a 2-1/2 inch square area that only needs to be trimmed if the vehicle is not equipped with an access hole for changing the oil.
Product Page this Question was Asked From
Curt Front Mount Trailer Hitch Receiver - Custom Fit - 2"
- Front Receiver Hitch
- Visible Cross Tube
- 350 lbs Vert Load
- 3500 lbs GTW
- 9000 lbs Line Pull
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Will the Curt 31055 Front Hitch Fit a 2002 TrailBlazer EXT?
- Q&A: Can The 31055 Fron Hitch Support A 82" x 19" Detail K2 Snowplow?
- Q&A: Retrax XR T-Track Tie-Downs Recommendation
- Q&A: Is there a Video that Shows How to Perform the Fishwire Technique to Install a Trailer Hitch
- Q&A: Difference Between Yakima Standard and HD Tracks
- Q&A: What is the Difference Between Yakima HD Tracks and Regular Yakima Tracks?
- Q&A: Recommended Front Hitch for 2005 Chevrolet Trailblazer