Where is the Trailer Wiring Connection Point for a 2007 Mitsubishi Endeavor
Updated 09/20/2011 | Published 09/19/2011
Question:
I would like to know exactly where the electrical connection is made. I dont see any wires inside the area around the spare tire and there are very few wires with access undr the rear of the vehicle.
asked by: Kirk F
Expert Reply:
The connection point for the Curt Wiring Harness, # C56039, on a 2007 Mitsubishi Endeavor is located under a floor panel adjacent to the spare tire compartment. What you will do is take off the floor hatch above the spare tire.
You will then need to temporarily remove all floor coverings, 10 mm storage tray bolts and storage trays, exposing the spare tire compartment. Remove drivers side and center foam cargo trays to locate tow plug housing under drivers side foam tray.
I have included a link to the installation details that show what you will be looking for.
Product Page this Question was Asked From
Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- Powered Converter
- No Tow Package
- 4 Flat
- Plug and Lead
- Plug-In
- Visible
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Tekonsha Brake Controller Wiring Adapter For A 2025 Ram 1500
- Q&A: Inner and Outer Diameter of the Chrome Edge Trim SAT012ET
- Q&A: Recommended Travel Trailer Stabilizer Jacks For 6,000LB Dry Weight Camper
- Q&A: How to Install Trailer Wiring on a 2004 Mitsubishi Endeavor Pulling a Boat Trailer with a 5-Way
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Where Does the 4-Flat Connector from Wiring Harness # C56039 go on a 2010 Mitsubishi Endeavor
- Q&A: Trailer Wiring Harness for 2004 Mitsubishi Endeavor
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)