How are Install Holes of Jensen Stereo # JWM60A Accessed
Updated 04/29/2020 | Published 07/09/2018
Question:
How do you mount the stereo onto the wall. I know you need the 4 screws but how do you get at the holes in the stereo to screw then in.
asked by: Mil
0
Expert Reply:
There is a trim piece that goes around the sides of the face plate of the Jensen Stereo # JWM60A that you referenced. With it removed you'd have access to the mounting hardware for the stereo. In the attached picture you can see the plates removed and the install holes accessible.
expert reply by:
Jameson C
0
click to enlarge
Continue Researching
- Q&A: Recommended Replacement Stereo for Jensen AWM970
- Q&A: Best Replacement for Linear Series RV5090 RV Stereo
- Q&A: Best Replacement for a Jensen RV Stereo AWM910
- Q&A: Recommended Replacement For A Magnadyne RV5090 RV Stereo System
- Q&A: Recommended Replacement for Old Jensen JWM6A RV Stereo
- Q&A: Recommended Replacement For An Estone RX8500 RV Stereo
- Q&A: Replacement RV Stereo Recommendation for a Genesis GT/ 2.0
- Article: Holiday 2025 | Staff Picks for Real-Life Adventures
- Article: How to Raise Your Travel Trailer Height
- Article: How Much Solar Power Do I Need For My RV?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Best Bike Racks for Electric Bikes
- Article: The Ultimate RV Camping Checklist for Your First Year RVing
- Article: Cleaning Your RV Black Water Tank in 4 Easy Steps
Jac
4/27/2020
I have the Jensen JWM60a installed in our new Keystone Residence and it was incorrectly wired, so my question is how to REMOVE the face plates in order to get at the wiring??