Does Switch of Edge EZ Programmer # EP30204 Have to be Used to Select Tune Level
Updated 06/11/2018 | Published 06/08/2018
Question:
Can you run a difrent control for selecting tunes other than the 3 way switch on the edge ez
asked by: Kody A
0
Expert Reply:
The toggle switch with the Edge EZ programmer # EP30204 is needed to select the power level you want. There's no other way to select the tune level you'd want.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Edge EZ for Dodge Cummins 5.9L, 24V, Common Rail
- Performance Chip
- Performance Tuners
- Tuner Only
- No Display Screen
- Yes - California Approved
- EZ
- Edge
more information >
Continue Researching
- Q&A: Can I Use Hubs with 3500-lb Capacity on Axle with 1750-lb Capacity If The Bearings Match Up?
- Q&A: Replacement Hub for Older Dexter 8-245
- Q&A: Replacement Switch and Cable Recommendation for Edge EZ Programmer # EP30204
- Q&A: Bearing Kit Recommendation for Dexter 8-248 Hub
- Q&A: Toggle Switch Positions on the Edge EZ Programmer 30204