Can Hooks be Easily Removed from Curt Safety Chains # C19749
Updated 05/09/2018 | Published 05/07/2018
Question:
Can these safety chains be shortened by removing one of the hooks? Can the hooks be removed without cutting the chain ?
asked by: Neil W
0
Expert Reply:
If you were to remove a hook from # C19749 the chains would be shorter. The only way to remove a hook, other than cutting the chain, would be to bend the "eye" end (where the chain connects to the hook) so you could then slide the chain off the long way. You couldn't go the short way because the keeper is riveted on. Are you looking for a specific chain length?
expert reply by:
Michael H
0
Product Page this Question was Asked From
Curt Safety Chains with Latching Hooks - 60" Long - 5,000 lbs - Qty 2
- Trailer Safety Chains
- 1/4 Inch Diameter
- Standard Trailer
- 60 Inch Long
- 5000 lbs
- Pair of Chains
- Snap Hooks
- CURT
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Gooseneck Pin Box for 2023 Keystone Montana 3231CK
- Q&A: Will The Air Lift 1000 Air Helper Springs Fit A 2025 Nissan Pathfinder Rock Creek?
- Q&A: Can Demco Surge Actuator Install on Trailer Tongue with Different Bolt Pattern
- Q&A: Replacement Parts Available for the RAM Trailer Jack Part # TJD-7000S
- Q&A: How Far from the Mounting Bracket is the Bottom of the etrailer Manual Sidewind Trailer Jack?
- Q&A: Should I Run the Spacer with the Timbren for 2025 Toyota Tundra
- Q&A: Repair Kit for etrailer Ram Jack # TJD-8000S
- Article: Trailer Wiring Diagrams
- Article: Determining Trailer Tongue Weight
- Article: How to Measure for Trailer Hitch Drop
- Article: RV Pre-Departure Checklist
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Lighting Requirements
- Article: How to Measure Your Trailer Wheel Bolt Pattern