Temporarily Disconnecting Edge Juice With Attitude CS2
Updated 05/01/2018 | Published 04/30/2018
Question:
I purchased the Edge Juice with Attitude CS2 for my 2016 Ram 2500. I need to take my truck to the dealer for some work due to a recalled part. How do I unhook the CS2 prior to taking the truck in for service? Is it as simple as unhooking from the OBD-II port and then removing the two cylinder harnesses and reinstalling the original two cylinder harnesses?
asked by: Jason
Expert Reply:
I reached to my contact at Edge and we confirmed when removing the Edge Juice with Attitude CS2 # EP31407, you need to remove the monitor from dash using the OBD-II cable. Also remove the under the hood module and jab wire. When reconnecting plug in all removed wires and restore # EP31407 to stock settings.
Product Page this Question was Asked From
Edge Juice with Attitude CS2 Performance Tuner - Color Screen - Dodge
- Performance Chip
- Performance Tuners
- Tuner Only
- Color Screen
- No - Not California Approved
- Juice with Attitude
- Edge
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Troubleshooting Weak Trailer Brakes on 2015 Ram 2500 with Factory Controller
- Q&A: How Long Is The RV Propane Gas Detector RS44FR Good For?
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Q&A: Comparing Dexter and etrailer Branded Electric Trailer Brake Assemblies
- Q&A: Replacement Monitor for Furrion Vision S Wireless Camera System
- Q&A: Can The Edge Juice CS2 Tuner # EP31407 Perform A DEF Delete And/Or Prevent LIMP Mode Temporarily?
- Q&A: What Hitch do You Recommend for My Keystone Raptor Toy Hauler?