Troubleshooting Left Stop/Turn Circuit Not Working on Trailer Wiring
Updated 03/19/2018 | Published 03/17/2018 >
Question:
My 2008 Tubdra left towing turn signal wire yellow has no power going to it at the trailer Plug. I’ve checked all of the “towing“ fuses in all of them are fine. And it seems all of the wires seems to be in good condition as well. Is there something I’m missing?
asked by: Rob R
Expert Reply:
Try inspecting the trailer connector front and back looking for any cut wires or corrosion that may be causing the problem. In most situations like this the problem is just some corrosionon the pin of the connector. The left turn/stop circuit of a 7-way is on the 9:00 pin position.
You can also use a circuit tester like part # 3808 to test the wiring of this circuit further and further up the wiring till you find the reason the circuit stopped working.
Product Page this Question was Asked From
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: How to Test Brake Controller without Trailer Connected
- Q&A: Recommended Bike Rack and Dual Hitch Adapter for Carrying E-Bikes While Flat Towing
- Q&A: Recommended Flat Tow Setup for a 2026 Ford Maverick
- Q&A: Looking for Replacement Hydraulic Gear Pump 196895
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Trailer Turn Signals Both Blink when Just Left Turn Signal is Activated
- Article: Brake Controller Installation: Starting from Scratch
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV
- Article: Brake Controller Installation for 2007 (New Body Style) - 2013 GMC Sierra and Chevy Silverado
- Q&A: Troubleshooting Right Side Trailer Lights Not Working, Left Side Working Correctly
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Q&A: How to Activate 12V Trailer Power Circuit on 2017 Ford F-350 Super Duty
- Article: 5 Reasons to Convert Your RV Lights to LEDs Today


