What Size Pin Hole Does the Replacement 2 Receiver Part # C45802 Use
Published 03/02/2018
Products Featured in This Question
Question:
What is the diameter of the 2 holes that attach this vertically and are adjustable on the shank?
asked by: Richard
0
Expert Reply:
The two holes that are used on part # C45802 to attach to an adjustable shank like part # 17120 are 5/8" in diameter which is the standard for 2" receiver tubes. You can use two of part # C21500 to attach it to the shank. It can be adjusted upward and downward on the shank depending on your specific needs. The complete unit with the shank, receiver, hitch balls, and hitch pin is part # D900 which I have attached a review video of for you.
expert reply by:
Conner L
0
Product Page this Question was Asked From
Replacement 2" Receiver for Curt Multi-Ball Adjustable Ball Mount
- Accessories and Parts
- Drop Hitch
- Trailer Hitch Ball Mount
- Receiver Tube
- CURT
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: How to Add a Ball Mount to the Curt Adjustable Weight Distribution Shank
- Q&A: Compatibility of the Curt Rebellion XD Dual Hitch Ball Attachment with Weight Distribution Shank
- Q&A: Tongue Weight Capacity of Patriot Hitch Adjustable Drop Hitch Receiver
- Article: How Level Should a Tow Bar Be When Flat Towing
- Q&A: Flange Width and Hitch Pin Dimensions for Curt Rebellion XD Adjustable Ball Mount
- Q&A: Torque Spec For Nut of Curt Hitch Ball Part # A-82
- Q&A: Does Gen-Y 14 Inch Hitch Extender Reduce Total Weight Capacity of Trailer Hitch
- Q&A: Can Gen-Y Hitch Extender be Used with Trailer with Less than 500 lb Tongue Weight
- Article: Is It Illegal to Leave My Hitch on My Truck?