What is Backing Plate and Door of Valterra City Water Inlet and Hatch A01-2000BKVP Made Of
Published 02/27/2018
Question:
Is the overall construction backing plate and door metal or plastic?
asked by: Tim
0
Expert Reply:
The backing plate and door for the Valterra City Water Inlet and Lockable Hatch for RVs # A01-2000BKVP is made of plastic.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Valterra Lockable Dual RV Water Inlets - City Water and Gravity Fill - Brass Valve
- RV Water Inlets
- City Fill Inlet
- Gravity Fill Inlet
- Surface Mount
- 5-7/8 Inch Diameter Cutout
- 1/2 Inch Deep
- Plastic
- 7-5/8 Inch Diameter Flange
- Brass
- Black
- Valterra
more information >
Continue Researching
- Q&A: Do You Sell A Hose/Shower For The B And B Molders BM82GR?
- Q&A: Does The RV High Flow Water Pressure Regulator Have A Built In Check Valve
- Q&A: Recommended RV Water Inlets For A 2005 Exiss Horse Trailer
- Q&A: Can the Rubber Be Replaced on Road Armor Shock Absorbing Equalizer Kit
- Q&A: What Should Tire Pressure be for a Load Range G 110 psi Tire
- Q&A: Comparing Road Armor, Dexter E-Z Flex, and MORryder CRE-3000 Equalizers For Jayco Eagle 325BHS
- Q&A: Recommended Replacement Screen Door Latch For Right Handed Screen Doors
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: Converting Your RV Water Heater to Tankless
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Cleaning Your RV Black Water Tank in 4 Easy Steps