Stromberg Carlson Folding Handrail AC-300 Install Fastener Size
Published 02/21/2018 >
Question:
Hello good morning I have a question about the AC-300 model what size is the hardware to secure the aluminum block to the wall
asked by: Roberto
0
Expert Reply:
I spoke with my contact at Stromberg Carlson and the Lend-a-Hand Folding Grab Handle for RVs, # AC-300, uses #14 x 2 inch screws. In order to mount the handrail you will want to drill 1/8 inch pilot holes making sure that you are drilling into a solid surface. They also recommend dabbing a small amount of caulk in the pilot holes before mounting the handle. This will help to keep water out.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Stromberg Carlson Folding Handrail for RVs - Stainless Steel - 24" Tall - 200 lbs
- RV Handrail
- Handrails
- Folding
- Stainless Steel
- Bolt-On
- 24 Inch Long
- Silver
- Stromberg Carlson
more information >
Continue Researching
- Q&A: Which Folding Handrail Is the Strongest? A Stainless Steel or Aluminum One?
- Q&A: Adapter to Allow LED Trailer Wiring to Connect to 2019 Ford F-150
- Q&A: What Steps Can the SafeStep Vinyl Barrier for TorkLift GlowStep Scissor Steps Be Used On
- Q&A: Will Lend-a-Hand Mini fit existing Winnebago grab handle holes? Mounting pattern and install guide
- Q&A: Tripod Stabilizer for Fifth Wheel Pin Box with Andersen Ultimate Connection Adapter
- Q&A: Comparing the Reese # RP500708 and Ultra-Fab Deluxe # UF17-943010 Landing Gear
- Q&A: Recommended Replacement Converter W/ Charger For Older 6300A Model 6332
- Article: Converting Your RV Water Heater to Tankless
- Article: Best RV Roof Vents
- Article: How to Replace or Install an RV Roof Vent
- Article: How to Install an RV Awning From Scratch
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?

