Recommended Solar Panel Connector to Replace Factory Furrion Solar Input on Trailer
Updated 02/20/2018 | Published 02/19/2018 >
Products Featured in This Question
Question:
Do you make the plug-in apparatus that connects the Renology solar charger to the Furrion connector at the trailer? Ive read on the internet that the part can be purchased, but one needs to solder the positive and negative wires. I dont have the equipment to solder the wires. Thanks.
asked by: Bryce E
Expert Reply:
We do not carry the solar connector as Furrion does not make them outside of their pricy briefcase solar panel. My recommendation is to change the ends of both connections to make compatible ends. I recommend the 2-Pole Socket Connector - Vehicle Side # PK12801 which doesn't require any soldering and the 2-Pole Trailer Wiring Connector - Trailer Side # PK12800 which again does not require soldering.
Product Page this Question was Asked From
2-Pole Trailer Wiring Connector - Trailer Side
- Trailer Wiring
- Trailer Connectors
- Trailer End Connector
- 2 Pole
- Plug Only
- Pollak
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Most Popular Wheel Bearings
- Q&A: Leaf Spring Bushings Closest to 1-1/4 Inch Outer Diameter
- Q&A: How to Wire Pollak 2-Pole Trailer Wiring Connector # PK12800
- Q&A: Equalizer Recommendation that is 7-3/4 inches Long and 2.875 inches Tall
- Q&A: Replacement Gear and Handle for Bulldog Jack BD195362
- Q&A: Replacement Hub for DICO 45264
- Q&A: Replacement Idler Hub For Old Boat Trailer With DICO 45264 Idler Hubs
- Q&A: Where Does 7-Way Trailer Wiring Install on 2006 Jeep Grand Cherokee
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Wiring Diagrams
- Article: How to Dump Black and Gray RV Waste Tanks
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Curt Echo Full Review
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)



