Construction of Carr Custom-Fit Side Step # CARR103991-1
Published 02/01/2018
Question:
What is the construction of these? Want something strong and no rust.
asked by: Ron
0
Expert Reply:
The Carr Custom-Fit Side Step # CARR103991-1 referenced in your question features an extremely durable, cast aluminum alloy construction. This will also do a great job of resisting rust and corrosion over time.
These steps have platforms that measure 7 inches long and 3-1/2 inches wide. All of the needed hardware is also included. I have attached the installation instructions that you can use for reference.
expert reply by:
Chris R
0
Product Page this Question was Asked From
Carr Custom-Fit Side Step - Hoop II - Black Powder Coated Aluminum - 7" Step - Qty 1
- Nerf Bars - Running Boards
- Side Steps
- 3-1/2 Inch Wide
- Matte Finish
- Fixed Step
- Aluminum
- Black
- Carr
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Need To Replace Dometic Awning MFR 916FT.21 501UL PNC 958603680
- Q&A: Is there Any Steps for My 1976 Chevrolet K5 Blazer that do Not Require Drilling to Install?
- Q&A: What Is A Good Adapter To Go From My 2 1/2 Hitch To A 2 Inch?
- Q&A: Where To Find The Factory Brake Controller Wire Harness In A 2023 Ford F-150
- Q&A: Comparing Hollywood Racks Sport Rider SE and RV Rider Bike Rack
- Q&A: Will the RockyMounts Backstage fit Electric Bikes with Fenders?
- Q&A: 1998 Ford E-350 Cargo Van Floor Mat Recommendation
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Rooftop Cargo Carriers
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Routing the Power Wire for a Trailer Wiring Harness