TorkLift GlowStep Revolution Vertical Stud Adapter Bracket Mounting Hole Dimensions
Updated 01/25/2018 | Published 01/23/2018
Question:
A few questions about the precise location of the pre-drilled holes in the mounting bracket for the Torklift Glowstep Revolution: 1 - What is the spacing of the holes in the horizontal lip at the top of the bracket? I need holes that will mate to holes in my mounting spar that are 7inch on center. 2 - How far below the lower surface of the horizontal lip are the holes on the vertical side members of the bracket? I am referring to the upper holes used for the bolts that mount the step assembly to the bracket. Thanks.
asked by: Tom R
Helpful Expert Reply:
The spacing on the holes center to center is 7-1/2". The drop from the top of the brackets to the step mounting holes is 1-1/4" to the center of the holes. The drop from the top bracket to the rear brace bracket center of slots is 4-3/4".
Product Page this Question was Asked From
TorkLift GlowStep Revolution Vertical Stud Adapter Bracket
- Accessories and Parts
- RV Steps
- Mounting Hardware
- Brackets
- TorkLift
more information >
Continue Researching
- Q&A: Bracket to Install TorkLift GlowStep Scissor Steps Under Wood Landing in Garage
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Q&A: TorkLift GlowStep Stow N' Go Scissor Steps for 2022 Arctic Fox 990 With Platform
- Q&A: Replacement Mounting Brackets for TorkLift GlowStep Camper Scissor Steps
- Article: How (and Where) to Connect an RV Propane Grill
- Q&A: How to Pick Out Correct Shackle Length for Trailer Suspension
- Q&A: How to Measure Replacement Shackles for Single Axle Trailer
- Q&A: Available 23-1/2 Inch Replacement Double Eye Spring
- Q&A: TorkLift Glowstep Revolution Size Selection