Sway Control Recommendation for Enclosed Tandem Trailer that Does Not Require Welding
Published 01/19/2018
Question:
I have a 7x14 tandem enclosed trailer I am looking to buy a sway control what would you recommend? Not sure if i have to weld or bolt on. I would prefer bolton Im pulling the trailer with a 16 Tahoe
asked by: Mike
0
Expert Reply:
The Reese Sway Control Kit part # 83660 can be bolted to the frame of your enclosed trailer. And if you use the ball mount bracket part # RP26003 you wouldn't have to have a tab welded to your ball mount either.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Reese Friction Sway Control Kit - Economy - by Draw-Tite, Reese and Hidden Hitch
- Weight Distribution Hitch
- Sway Control Only
- Reese
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Which Sway Control Hitch is Right For Your Trailer?
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: What Ohms Should Trailer Brake Magnets Be?
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft
- Q&A: Replacement For Hub & Drum 8-207
- Article: Holiday 2025 | Best Gifts for RVing
- Q&A: Troubleshooting Curt TruTrack Not Leveling Truck After Installation and Maximum Adjustment
- Q&A: Where to Install Transmission Cooler on a 2006 Toyota Sienna
- Q&A: U-Bolt Torque Recommendation for 1/2 inch Diameter On Trailer Suspension
- Q&A: Recommended Replacement for Imperial 55 Inch Side-Door Bar Lock
- Article: Trailer Lighting Requirements
- Q&A: Can I Get Key 0370 For The Master Lock Coupler Lock ML377KA
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?