Where Does Kats Heaters Oil and Coolant Immersion Heater Install?
Published 01/16/2018
Question:
was looking at engine block warmer,KH30904,just where do you insert it to properly work?
asked by: Mike C
1
Helpful Expert Reply:
The Kat's Heaters Oil and Coolant Immersion Heater # KH30904 is a 3-3/4" long immersion heater which simply screws into either the oil pan or engine block of your vehicle. Once inserted you'll only need to route the power cord through the grille and plug it in and it'll be ready to go. The cord does detach from the screw-in element so you won't need to permanently route the cord.
expert reply by:
Kyle S
1
Product Page this Question was Asked From
Kat's Heaters Oil and Coolant Immersion Heater - 120V - 300 Watt - 1/2" NPT
- Oil Pan Heater
- Immersion Heater
- 1/2 Inch NPT
- 120 Volts
- 300 Watts
- CSA Approved
- Kats Heaters
more information >
Continue Researching
- Q&A: Can I Use the Same Magnetic Heater Pad For Tractor And Generator Motor Oil?
- Q&A: Can Magnetic Oil Pan Heater Stay On While Driving Diesel Truck In Winter?
- Q&A: Will The Kat's Heaters Oil And Coolant Immersion Heater Work With A Cub Lawn Tractor
- Q&A: Recommended Replacement Side Marker Light for Exiss Horse Trailer
- Q&A: How Hot Does Kat's Heaters Oil and Coolant Immersion Heater Get
- Q&A: What MORryde Equalizer For Triple Axle Trailer With 7-3/4" Long Equalizer
- Q&A: Will an Engine Oil Heater Help Me Start My Generator in the Cold